Call us: +91 - 9925460107

D+ EPOXY GROUT

Benefits

Clear, synthetic polymer emulsions 

Features

for interior and exterior locations in dry and wet places

Uses

glass mosaic, heated screeds, vitrified tiles, timber floors

Surface preparation:
Clean the groves by removing the dust and dirt. 
Application:

1. Spread not more than 1 sq.m. at a time, apply the adhesive to the floor surface.
2. Comb the adhesive to the required depth (between 3-6mm) using a suitable trowel.
3. Press the tiles firmly into position with a slight twisting action, checking periodically that good contact is maintained with the back of each tile. Leave no voids behind tiles when solid-bed fixing.
4. Tiles should be fixed within 10 minutes of adhesive being applied, depending on the porosity of the surface and atmospheric conditions. Tiles can be adjusted up to 5 minutes after fixing. Touch the adhesive ribs periodically and if a skin has formed, remove the adhesive and apply a new layer.
5. Leave adequate joints between individual wall and floor tiles unless self spacing tiles are used.
6. Clean off surplus adhesive from the tile face and between joints.
7. Do not use in damp conditions.

precautions:

Care should be taken to avoid staining tile / stone when grouting with coloured grout. This is especially applicable when grouting unglazed floor tiles / stone, quarry textured surface, Check the potential risk of staining by applying the grout to a few tile / stone in a small trial area.

Other Products Range

PUREN AP 49
Read more...
DFR 108/ DFH 208/ ACCELERATOR
Read more...
D+ EPOXY GROUT
Read more...

Send Email / SMS Enquiry

D+ EPOXY GROUT

Get In Touch